Zanelli Argon Line Single Shaft Mixer/Disperser

Zanelli Argon Line Single Shaft Mixer/Disperser

The Argon Line CI is a single shaft mixer/disperser and has an electrical motor complete with a frequency converter. The power transmission between the electric motor and the mixing shaft occurs in a direct way by means of a shaft coupling. This machine is suitable to mix or disperse products having a low or medium viscosity up to about 25.000cP. The vertical stroke of the mixing shaft is obtained through two pneumatic pistons.

TURBODISPERSER ARGON LINE MODEL CI

Main transmission Electrical motor complete with frequency converter. Power transmission between the electric motor and the mixing shaft occurs in a direct way by means of a shaft coupling.

Auxiliary Hydraulic Power Pack Hydraulic power pack positioned in the machine structure, complete with an electric motor, coupling strainer, coupling, pump, solenoid valves, oil level, vent, drain cock and safety devices. The power pack actuates the hydraulic cylinder, complete with a safety lock valve. The cylinder is placed in the centre of the two fixed columns and is suitable to lift up the entire mixing group.

Mixing tools Dispersion shaft in AISI 304 stainless steel, balanced with an adequate taper on the edge, in order to ensure the elimination of vibrations even in the most critical stages of processing and at high-speed rates. The change in speed of the mixing shaft is obtained by means of an electronic system complete with frequency drive (inverter). The advantage is that the operator has a range of speeds available but especially there is a high torque even at medium/low speeds. Continuously variable speed. The dispersion tool, supplied with the machine, is a toothed impeller with an easy fixing to the shaft, easy to replace.

Mixing shaft vertical stroke The impeller vertical movement, stroke, is obtained by 2 guide rods complete with sliding supports. The system allows also to lock the cover in the upper position to facilitate the washing phase of the dispersion shaft, in a totally safe way. The possibility to adjust the correct height of the mixing/dispersion tool, according to the quantity of product contained in the vessel, gives the machine a high degree of flexibility and also allows to optimize the mixing flow, ensuring fast incorporation of raw materials. The stroke is achieved by lifting the mixing group to which a sleeve is fixed, that acts as a holder support for bearings of the mixing shaft, protected by a sliding bellow, bound to the sleeve and to the lid of the machine.

Mixing vessel Vessel made of AISI 304 stainless steel. AISI 304 stainless steel reinforcement top ring. Intermediate band, in AISI 304 stainless steel, with fixings to support basement. Vessel with rounded bottom and connected to vertical plating. Discharge in the central part.

Frame The structure of the machine, called a frame, is composed of sturdy construction in carbon steel, treated with two-component epoxy paint. It is complete with a base plate with suitable holes for fixing to the floor, by means of chemical anchors brackets. N.2 linear guides, recirculating balls, fixed inside the structure, with suitable size to support the mixing group.

Options:

• ATEX EXECUTION